The conductor erection is the key point of the high-voltage transmission line design of the entire power project, especially one of the key points of the design. Inner Mongolia Power Installation In the preliminary preparation stage of conductor erection, the relevant design staff should strictly and systematically master the construction equipment, and formulate the corresponding design and construction forms to ensure the smooth erection of the entire conductor. Generally speaking, the conductor erection works shall be carried out from the following two aspects: 1. Design the setting out of the conductor. The designer shall ensure the quality of the conductor and observe whether the conductor is split. Once the quality problem of the defense line is found, it shall be solved immediately.

2: Design the wiring of wires.

The design of conductor connection is the key point of the design of the whole conductor erection project, which is crucial to the normal operation of high-voltage transmission lines. In general, the connection design of overhead lines includes the connection of overhead conductors, as well as the connection between overhead conductors and crimped strain clamps. In the design, it is necessary to ensure that each conductor is properly connected. Only in this way can the design of the entire conductor erection project really play its role.

Design of lightning conductor

In the design of high-voltage transmission lines, the design of lightning conductors cannot be ignored, Inner Mongolia power installation price But many designers often neglect the design of the lightning conductor when designing the line, which has caused serious consequences. The following points shall be achieved in the design of lightning conductor:

1: The lightning conductor shall be selected.

In the process of line design, the designer should select double lightning wires, which can ensure that the conductor is not affected even if the lightning is mixed, and protect the conductor as effectively as possible.

2: Install lightning rod.

Generally speaking, the lightning rod should be installed on the top of the tower, and at the same time, the lightning strike point should be effectively controlled to minimize the number of lightning strikes and improve the lightning protection effect.

3: A certain distance can be set in the vertical direction between the lightning rod and the high-voltage conductor.

With the development of society, some lightning rods with lightning suppression function have appeared one after another. The design of horizontal distance and the scientific use of lightning rods can greatly reduce the harm of lightning strikes on high-voltage lines and ensure that high-voltage transmission lines play a scientific role. Setting lightning protection lines is an important way to conduct lightning protection design. However, in the past design of high-voltage transmission lines, some designers would completely ignore the lightning protection design. On the one hand, this is irresponsible for the design itself. On the other hand, the installation of power in Inner Mongolia is also not conducive to protecting high-voltage conductors and promoting the normal power supply of high-voltage conductors Transmission function.